Kwikset 913TRL 11P UL Installationsanleitung Seite 1

INSTALLATION GUIDE • GUÍA DE INSTALACIÓNTools NeededHerramientas necesariasAAAAAAAARQACDBEFGHJMLNPKUse and programming instructions are located on the

MInsert key and test latch. If latch does not extend or retract smoothly, adjust screws (H). Remove key when finished and make sure the latch bolt is

MInsert key and test latch. If latch does not extend or retract smoothly, adjust screws (H). Remove key when finished and make sure the latch bolt is

JJLay excess cable flat inside the bottom of the interior housing (J).Acomode el exceso de cable en el fondo del alojamiento interior (J).Ensure tight

JJLay excess cable flat inside the bottom of the interior housing (J).Acomode el exceso de cable en el fondo del alojamiento interior (J).Ensure tight

latch boltperno de retenciónProgram the lock. See the User Guide on the reverse side of this manual.Programe la cerradura. Consulte la Guía del usuari

latch boltperno de retenciónProgram the lock. See the User Guide on the reverse side of this manual.Programe la cerradura. Consulte la Guía del usuari

MNPQball tippunta de bolax3If needed, rekey the lock to work with your existing key. See the supplied SmartKey Rekey instructions for more information

MNPQball tippunta de bolax3If needed, rekey the lock to work with your existing key. See the supplied SmartKey Rekey instructions for more information

FoldDoble1-3/4" (44 mm)1-3/8" (35 mm)2-3/8" (60 mm)2-3/4" (70 mm)Edge • Borde BacksetDistancia al centroFace • Frente CenterlineLi

FoldDoble1-3/4" (44 mm)1-3/8" (35 mm)2-3/8" (60 mm)2-3/4" (70 mm)Edge • Borde BacksetDistancia al centroFace • Frente CenterlineLi

Options for Select Models OnlyOpciones solamente para modelos selectosDo not use electric drill or electric screwdriver to tighten screws.No utilice e

Options for Select Models OnlyOpciones solamente para modelos selectosDo not use electric drill or electric screwdriver to tighten screws.No utilice e

1"25 mm2-1/8"54 mm1-1/2"38 mm1-3/8" – 1-3/4"35 mm – 44 mm2-3/8" (60 mm)or • o 2-3/4" (70 mm)oro180°Check Dimensions

1"25 mm2-1/8"54 mm1-1/2"38 mm1-3/8" – 1-3/4"35 mm – 44 mm2-3/8" (60 mm)or • o 2-3/4" (70 mm)oro180°Check Dimensions

1-1/2"38 mmATest if latch bolt fully extends and retracts. Chisel out area inside hole as needed so latch can operate smoothly.Pruebe si el perno

1-1/2"38 mmATest if latch bolt fully extends and retracts. Chisel out area inside hole as needed so latch can operate smoothly.Pruebe si el perno

GECable goes underneath latchEl cable va por debajo del pestilloRoute cable through center hole, then push cable into bottom hole.Conecte el cable a t

GECable goes underneath latchEl cable va por debajo del pestilloRoute cable through center hole, then push cable into bottom hole.Conecte el cable a t